AS 1892.1:2018 PDF
Sets out requirements for the design and manufacture of portable ladders from various materials and combinations of materials, such as metal, plastic, reinforced plastic, other composites, ceramics, timber and engineered wood.
This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee SF-034, Portable Ladders, to supersede AS/NZS 1892.1:1996, Portable ladders, Part 1: Metal and AS/NZS 1892.3:1996, Portable ladders, Part 3: Reinforced plastic.
After consultation with stakeholders in both countries, Standards Australia and Standards New Zealand decided to develop this Standard as an Australian Standard rather than an Australian/New Zealand Standard.
This Standard is Part 1 in a series of Standards covering the safe design, manufacture and use of portable ladders and attachments. Other Standards in the series are as follows:
AS 1892.2, Portable ladders, Part 2: Timber
AS/NZS 1892.5, Portable ladders, Part 5: Selection, safe use and care
In this edition Parts 1 and 3 have been consolidated into a single document. Design and performance requirements for metal and fibreglass ladders remain the same, except for the following:
(a) Addition of test reporting requirements (Clause 1.7).
(b) Additional labelling requirements (Clause 2.8).
(c) Addition a new classification for ladders with ‘higher stability’ (Clause 1.5.33).
(d) Addition of test and performance criteria for ‘higher stability’ ladders (Appendices GG, HH and II).
(e) Clarification of which test methods apply to each type of ladder (Section 8).
(f) Addition of particular requirements for work platforms (Section 9).
(g) Addition of particular requirements for step stools (Section 10).
