AS ISO/IEC 14443.3:2022 PDF
AS ISO/IEC 14443.3:2022 identically adopts ISO/IEC 14443 3:2018, which describes various characteristics and capabilities of proximity cards or objects (PICCs) and proximity coupling devices (PCDs).
This Standard was prepared by the Standards Australia Committee IT-017, Cards and security devices for personal identification, to supersede AS 14443.3:2003, Identification cards — Contactless integrated circuit(s) cards — Proximity cards, Part 3: Initialization and anticollision.
The objective of this document is to describe the following:
(a) Polling for proximity cards or objects (PICCs) entering the field of a proximity coupling device (PCD).
(b) The byte format, the frames and timing used during the initial phase of communication between PCDs and PICCs.
(c) The initial Request and Answer to Request command content.
(d) Methods to detect and communicate with one PICC among several PICCs (anticollision).
(e) Other parameters required to initialize communications between a PICC and PCD.
(f) Optional means to ease and speed up the selection of one PICC among several PICCs based on application criteria.
(g) Optional capability to allow a device to alternate between the functions of a PICC and a PCD to communicate with a PCD or a PICC, respectively. A device which implements this capability is called a PXD.
Protocol and commands used by higher layers and by applications and which are used after the initial phase are described in AS ISO/IEC 14443.4:2022.
This document is applicable to PICCs of Type A and of Type B (as described in AS ISO/IEC 14443.2:2022), to PCDs (as described in AS ISO/IEC 14443.2:2022) and to PXDs.
This document is identical with, and has been reproduced from, ISO/IEC 14443-3:2018, Cards and security devices for personal identification — Contactless proximity objects — Part 3: Initialization and anticollision and its Amendment No. 1 (2021) and Amendment No. 2 (2020) which have been added at the end of the source text.
As this document has been reproduced from an International document, a full point substitutes for a comma when referring to a decimal marker.
Australian or Australian/New Zealand Standards that are identical adoptions of international normative references may be used interchangeably. Refer to the online catalogue for information on specific Standards.
The terms “normative” and “informative” are used in Standards to define the application of the appendices or annexes to which they apply. A “normative” appendix or annex is an integral part of a Standard, whereas an “informative” appendix or annex is only for information and guidance.
